10/25/2023 0 Comments Autodesk inventor 2015 frame generatorNew users may not have figured out that you can select as many frame members to trim as you like, all in one command instance. I spoke of the Trim to Face tool recently, that is a great way to hack off frame members when the underlying sketch geometry needs to be long. Now that the frame is placed, I need to trim off the lower section of excess frame. Grab multiple frame members to be trimmed along same plane Repeat the process of getting the first in a run set how you like it, and Inventor will apply the remainder properly. Then we can move on to the next grouping. Now we can pick the remaining frame locations IN-LINE, and Inventor will align the remaining frame members accordingly. No problem, we just pick the correct alignment. In the example below, you see how the Inventor’s Frame Generator defaults to the center of the frame. If all the planets are not in alignment, at least one frame member will be wrong. You cannot set all frame members in one shot. There is a better way – it is all in how you apply the frames. To make matters worse, there is no way to individually alter these while applying them as a group. Picking frame locations to be applied in a single pass causes numerous frames to offset to the wrong side of the profile. If you are new to Frame Generator, you may have run into problems with frame alignment on 2D Sketch Geometry. Many of these are from older workflows, and some are new to 2012. I began a new machine configuration recently, and during the process, picked out a few tidbits that I thought some of you might like.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |